located at the bottom of the transmission (No. 2 in Figure 17). The
transmission refueling hole is located at the upper rear part of the
transmission (No. 1 in Figure 16).
Method of replacing the oil: Pass the No.13 sleeve through the motor guard
plate, loosen and screw out the bolt (No. 2 in Figure 17), then the oil flows
out of the hole until it is clean. Screw the bolt back with the sleeve and
tighten it. Unscrew the bolt of the transmission fuel hole (No. 1 in FIG. 16)
with the No.14 wrench and add 130ml oil, the oil brand is SM-1018. It is
recommended to change the transmission oil every six months, and the first
oil change is recommended after 3 months after riding.
（Figure 16） （Figure 17）
1.Transmission filling hole 2.Transmission oil drain hole
5.17 Back handle：
The rear handle (No. 2 in Figure 18) is detachable and is attached to the
frame mount.
Rear handle installation: two screws on each side of the rear handle are
installed on both sides of the frame. The holes on both sides are well
aligned and fixed and locked with M8 screws;
（Figure 18）
1.Rear handle mounting bolt 2.Rear handle
To Next Page
Loading...