GPro V25 - Low Flow Rate Solutions

5
EN
SYMPTOM POSSIBLE CAUSE
(
S
)
CORRECTIVE ACTION
C.Lowowrate 1. Strainer partially
clogged
1. Inspect strainer (see
Maintenance/Repair
section). Replace, if
necessary
2. Poor connections
or low voltage
2. Make sure electrical
connections are secure.
Also check battery voltage
3. Fuel tank low/empty 3. Fill tank
4. Suction pipe clogged
or damaged
4. Remove pump from tank.
Inspect suction pipe. Clean
or replace, as necessary
5. System air leak 5. Tightenallpumpttings
and connections. Inspect
suction pipe for leaks or
damage. Replace, as
necessary
6. Strainer clogged or
defective
6. Inspect strainer (see
Maintenance/Repair
section). Replace, if
necessary
7. Vanes worn or sticking 7. Check slots and vanes
for excessive damage.
Replace if damaged
8. Bypass poppet
O-ring worn or missing
8. Inspect O-ring (see
Maintenance/Repair
section). Replace, if
necessary
9. Bypass poppet binding
or damaged
9. Remove the bypass
poppet, spring, and O-ring.
Clean cavity. Inspect and
replace components, if
needed
10. Outlet is blocked 10. Check all accessories for
blockage. Remove any
obstructions
11. Usingo󰀨-the-shelf
automatic nozzle
11. Factory-supplied automatic
nozzle is recommended
12. Hose damaged 12. Replace hose
13. Faulty Nozzle 13. Removenozzle.Checkow
back into tank. Replace
nozzle if necessary.
TROUBLESHOOTING
(
CONTINUED
)