Need help?Do you have a question about the Graco FastAction SE and is the answer not in the manual?
Follow all warnings to prevent injury or death. Includes child restraint, tipping, burns, and entanglement hazards.
This stroller is ONLY compatible with Graco® SnugRide® infant car seats with Click Connect™.
Check all parts before assembly. No tools are required for assembly of this product.
Prepare assembly area. Unfold and securely latch the stroller to ensure it is fully open.
Attach canopy by wrapping elastic loops around wire and inserting into mounts.
Connect front wheels to leg tubes. Verify secure attachment by pulling.
Align brake levers rearward. Insert axle rod and secure wheels. Repeat for other side.
Secure child with seat belt before attaching tray. Tray is not a restraint device.
Always use the 5-point harness system. Properly open, adjust, and close harness straps.
Engage both brakes to lock. Disengage by lifting. Test brakes by pushing the stroller.
Open and close the canopy. Adjust the canopy window flap as needed.
Ensure child's limbs are clear. Push button to recline seat; pull straps to raise seat.
Pull the fold/unfold strap up. Rotate handle down to fold. Stroller will lock when folded.
Use only compatible Graco® Click Connect™ car seats. Secure child with harness in car seat.
Check stroller regularly. Clean with mild soap and water. Dry thoroughly if wet. Avoid extreme heat/sun.
Contact Graco for replacement parts, accessories, or warranty. Visit gracobaby.com.
Register your Graco product online for US residents at gracobaby.com/productregistration.
To Next Page
General