Graco LANDMARK - Rear-Facing LATCH Installation Steps

20
3 Rear
Facing
5. Place Car Seat Rear-Facing
in Back Seat of the Vehicle
Place the base flat on the vehicle seat.
Push it back until the front of the car seat
touches the vehicle seat back. Center
the car seat between the lower LATCH
anchors.
6. Check the Rear-Facing Level
Indicator
Vehicle MUST be on level ground. Ball
must be completely in the blue zone.
Readjust the incline if needed. Or if
needed, rolled towels may be placed
under the car seat at the vehicle seat
crease, until the ball is completely in the
blue zone.
7. Connect LATCH Connectors
to Vehicle’s Lower LATCH
Anchors.
LATCH strap should lay as flat as possible
and not be twisted.
LATCH can only be used if the vehicle
LATCH anchor spacing is 11 inches
(28 cm) from the center of one LATCH
anchor to the center of the other
LATCH anchor.
¡
E
l
i
n
d
i
c
a
t
o
r
d
e
b
e
m
a
n
t
e
n
e
r
s
e
e
n
a
z
u
l
!
Ball MUST BE entirely in blue.
REAR-FACING
ORIENTADO HACIA ATRÁS
11” (28 cm)