Graco LANDMARK - 3-C Install Rear-Facing With Vehicle Seat Belt

23
3 Rear
Facing
3-C Install Rear-Facing With Vehicle
Seat Belt
1. Recline the Car Seat
Place the car seat in recline position 1 or 2.
1
2
PD276538A
3
F
O
R
W
A
R
D
-
F
A
C
I
N
G
R
E
A
R
-
F
A
C
I
N
G
B
O
O
S
T
E
R
4
3. Place Car Seat Rear-Facing
in Back Seat of the Vehicle
Place the base flat on the vehicle seat.
Push it back until the front of the car seat
touches the vehicle seat back.
4. Check the Rear-Facing Level
Indicator
Vehicle MUST be on level ground. Ball
must be completely in the blue zone.
Readjust the incline if needed. Or if
needed, rolled towels may be placed
under the car seat at the vehicle seat
crease, until the ball is completely in the
blue zone.
2. Store Top Tether and LATCH Straps
Store top tether hook as shown. Push in
on the red buttons and attach the LATCH
connectors to plastic bar as shown.
Remove the slack from both straps.
¡
E
l
i
n
d
i
c
a
t
o
r
d
e
b
e
m
a
n
t
e
n
e
r
s
e
e
n
a
z
u
l
!
Ball MUST BE entirely in blue.
REAR-FACING
ORIENTADO HACIA ATRÁS