6
LATCH System
LATCH consists of two lower anchors, which are built-in to your
vehicle, and connecting hooks that are built-in your car seat.
Review section 3-B, 4-B & 5-B of this manual AND your vehicle
owner’s manual.
LATCH can ONLY be used if the vehicle LATCH anchor spacing
is 11 inches (28 cm) from the center of one LATCH
anchor to the center of
the other LATCH anchor.
When Installing This Car Seat
Vehicle Seat Belt
There are two types of vehicle seat belts that can be
used When Installing Rear-Facing & Forward-Facing. Lap/
Shoulder Seat Belt or Lap Only Seat Belt.
Only use the Lap/Shoulder seat belt configuration when
Installing As a Booster
Review section 3-C, 4-C & 5-B of this manual AND your
vehicle owner’s manual.
Does Your Car Seat Fit Your Child Correctly?
To make sure your child is secured properly, review section 3, 4 & 5 to understand all
of the actions you need to take to properly adjust the car seat to fit your child.
Harness Height, Rear-Facing (A)
Harness straps at or just below the child’s shoulders and
top of head must be 1” (2.5 cm) below the headrest adjustment
lever
(B). Review section 6.
Buckle Position (C)
The correct slot is the one that is closest to your child
without being underneath them. Review section 6.
Harness Tightness (D)
If your fingers slide off the harness straps without
pinching the straps, it is tight enough. Review section 6.
For Rear-Facing, You Need to Adjust:
A
C
B
D
To Next Page
Loading...
