Graco Reactor H-25 Series Repair And Parts

Parts
312063Z 53
 Replacement Danger and Warning labels, tags, and
cards are available at no cost.
 Not shown.
 Required for all A-D series models. Included in
Knob Repair Kit 258920 (purchase separately).
 Fluid Inlet Kit (59) has two versions: Series A and
Series B. Fluid Inlet Kit Series A uses a flat gasket
(59h) and can be identified by a white seal. The
gasket material has been upgraded for improved
sealing and is now a light gray color. Fluid Inlet Kit
Series B, shown on page 51, uses an o-ring seal
(59h) with a different manifold (59d) and strainer plug
(59j). The seal is not visible when fully assembled.
† Included in Strainer Manifold Kit 247503.
‡ Series A manifold is not available. Order
replacement kit 247503.
66 ---- CONNECTOR, 2 PIN, motor
power; see page 54 for part
numbers
1
67 117284 GRILL, fan guard 1
68 ---- SWITCH, added pole; see page
54 for part numbers
74 206995 THROAT SEAL LIQUID; 1 quart 1
76 115836 GUARD, finger 1
77 186494 CLIP, spring 5
78 205447 COUPLING, hose 2
79 054826 TUBE, PTFE; 1/4 in. (6 mm) ID; 8
ft (2.4 m)
8
82 15H207 BRACKET, tensioner 1
84 189285 LABEL, safety, burn hazard 2
85 114269 GROMMET, rubber 2
88 247851 FITTING, reducer #5 x #8 JIC 1
89 247852 FITTING, reducer #6 x #10 JIC 1
90 111802 SCREW, cap, hex hd; 1/2-13 x 3/4
in. (19 mm)
2
92 112958 NUT, hex, flanged; 3/8-16 4
93 15T895 HOSE, supply 1
94 247784 TUBE, return 1
96 247853 ADJUSTER, belt, tensioner 1
97 15G816 COVER, plate, wire way 1
98 120302 CASTER 4
99 112125 PLUG, tube 2
100 ---- LABEL; see page 54 for part
numbers
1
102 15H189 BOOT, wire feed through 1
103 ---- CONDUIT, assembly, motor
power; see page 54 for part
numbers
1
107 119253 SUPPRESSOR, ferrite; 151 ohm 1
110 247826 RESERVOIR, hydraulic; includes
110b-110m; see page 51
1
110b 247778 . HOUSING, inlet 1
110c 247771 . GASKET, inlet 1
110d 247777 . TUBE, inlet 1
110f 247770 . TUBE, return 1
110j 25D893 . FILTER, inlet 1
110k 255032 . PLUG 1
110m 255021 . FITTING, straight 1
111 247822 BRACKET, motor mount 1
112 BRACKET, mounting, pump 1
247819 H-40, H-50, H-XP3 models only
247830 H-25, H-XP2 models only
113 PUMP, hydraulic 1
255019 H-40, H-50, H-XP3 models only
247855 H-25, H-XP2 models only
114 247821 BRACKET, reservoir, hydraulic 2
115 247820 BRACKET, support, pumpmount 1
116 247829 COOLER, hydraulic 1
117 ---- ELBOW; 1-1/16 npt(m) x 1/2 in.
(13 mm) tube
1
255020 H-40, H-50, H-XP3 models only
255035 H-25, H-XP2 models only
118 ---- PULLEY, fan 1
247856 H-40, H-50, H-XP3 models only
Ref. Part Description Qty.
247857 H-25, H-XP2 models only
119 15H512 LABEL, control 1
120 15H204 KNOB, pressure 1
122 117560 SCREW, set, socket hd 1
125 247793 HOSE, inlet, coupled 1
126 255029 GAUGE, pressure, fluid, panel
mount
1
127 ---- ELBOW 1
121320 H-40, H-50, H-XP3 models only
121321 H-25, H-XP2 models only
129 255036 ELBOW, male 1
130 117792 GUN, grease 1
131
117773 GREASE, lubricant 1
132 15G782 HOSE, coupled 1
133 15G784 HOSE, coupled 1
134 116915 DIPSTICK with breather cap 1
135 247792 FILTER, oil,18-23 psi bypass 1
137 FITTING 1
116793 H-40, H-50, H-XP3 models only
110792 H-25, H-XP2 models only
139 107156 SCREW, cap socket head 3
140 115764 FITTING, npt (part of hydraulic
pump assembly); H-25, H-XP2
models only
1
141 112161 SCREW (part of hydraulic pump
assembly); H-25, H-XP2 models
only
2
142 112586 SCREW, cap, hex hd 2
143 110996 NUT, hex, flange hd; 5/16-18 2
144 C19862 NUT, lock, hex 1
146 247836 COVER, access 1
147 255048 NUT, strain relief, M40 thread 1
148 255039 CONNECTOR, heater 1
150 ---- SCREW, set; 1/4 x 1/2 (13 mm) 2
151 261821 CONNECTOR, wire, 6 AWG (pair) 1
153 104373 WASHER, thrust 2
154 127816 STRAIN RELIEF 2
Ref. Part Description Qty.

Graco Reactor H-25 Series Specifications

General

Brand	Graco
Model	Reactor H-25 Series
Category	Paint Sprayer
Language	English