Graco REMIX - Page 17

To Next Page

To Previous Page

6. Gire el alambre del asiento hacia

arriba y trábelo en los montantes

como se indica.

6. Rotate seat wire up and lock into

mounts as shown.

7. Sujete las aletas alrededor del

alambre con los 3 broches.

7. Secure flaps around wire with

3 snaps.

Main Page

Contents2
Warning4
Use Positions9
Parts List10
To Open Stroller11
Rear Wheels12
Front Wheels13
Cup Holder and Phone Holder14
Assembling Toddler Seat15
To Attach Canopy18
To Attach/Remove Toddler Seat20
To Remove Toddler Seat21
Arm Bar22
Canopy24
To Secure Child26
5 Point Harness26
3 Point Buckle27
Use28
Adjusting Shoulder Harness Position28
To Recline30
Brakes31
Swivel Wheels32
Reclined Carriage Position33
To Attach Graco Infant Car Seat to Toddler37
To Attach Graco Infant Car Seat to Stroller Frame41
To Fold Stroller Frame Without Toddler Seat43
To Fold Stroller with Toddler Seat Attached45
Arm Bar Cup Holder (on Certain Models)47
Body Support48
Harness Covers48
Care & Maintenance49
To Clean Seat Cover49
To Clean Stroller Frame49
To Clean Cup and Phone Holders49
Replacement Parts52
Rear-Facing Use54
Securing Child55
Get to Know Your Car Seat56
What Seating Location Should I Use?56
Which Installation Method Should I Use?56
When Installing Base57
LATCH System57
Vehicle Seat Belt57
When Installing Carrier57
Does Your Seat Fit Your Child Correctly?58
You Need to Adjust58
Harness Height58
Buckle Position58
Cannot Pinch Harness59
Before You Begin60
Register this Child Restraint60
Car Seat’s Useful Life62
Vehicle Seat Protection62
Warm Weather Use62
Safety Warnings63
Car Seat Features66
Remove Car Seat from Base70
Attach Car Seat to Base70
Adjusting Carry Handle71
To Rotate Handle71
Handle Has 4 Positions71
Recline the Base72
Recline Positions72
Choosing Vehicle Seat Location74
Choosing LATCH or Seat Belts75
What Is LATCH?75
Rear-Facing Safe Use Checklist76
LATCH Strap76
Vehicle Lap/Shoulder Seat Belt76
Vehicle Lap Only Seat Belt77
Vehicle Lap/Shoulder Seat Belt Without Base77
Vehicle Lap Only Seat Belt Without Base77
Install with Base Rear-Facing with LATCH Strap78
Check the Rear Facing Level Line82
Is Everything Correct?83
Install with Base Rear-Facing with Vehicle Seat Belt84
Install Without Base Rear-Facing with Vehicle Seat Belt90
Route the Vehicle Seat Belt91
Lock the Vehicle Seat Belt91
Tighten the Vehicle Seat Belt92
Test for Tightness92
Securing Child95
Adjust Harness to Fit Child95
Loosen Harness Straps95
Release the Chest Clip95
Unbuckle the Buckle96
Place Your Child in the Seat96
Check Harness Height97
To Change Harness Height Positions98
Insert Harness Strap into the New Location98
For Smaller Baby99
For Larger Baby100
Adjust Buckle to Fit Child101
Check the Buckle Position101
To Change Buckle Position101
Insert Metal Clip into New Location102
Pull up on Buckle to Check It Is Secured102
Securing Child in Car Seat103
Removing Child106
Carrier Use107
Additional LATCH Information109
How to Remove LATCH110
Unsafe Vehicle Seats111
Vehicle Seat Belts111
Vehicle Seat Belt Terms112
Retractor112
Latch Plate112
Identify Your Seat Belt Type112
Lap/Shoulder Seat Belt Installation114
How to Lock Your Lap/Shoulder Vehicle Seat Belt115
Sliding Latch Plate and Switchable Retractor115
Locking Latch Plate and ELR Retractor116
Sliding Latch Plate and ALR Retractor117
Sliding Latch Plate and ELR Retractor118
Lap Belt Installation119
Locking Latch Plate and no Retractor119
Sewn on Latch Plate and ALR Retractor119
Accessories120
Body Pillow120
Harness120
Cleaning Seat Pad121
Cleaning Buckle124
Remove Buckle to Clean124
Replacement Parts128

Graco REMIX - Page 17

Table of Contents

Related product manuals