Graco Turn2Me - Page 63

63
Rear Facing with Seat Belt
3-C
Keep hands away from the lock-off
area when closing the lock-off.
CLICK!
11. Tighten the Vehicle Seat Belt
Press down firmly in the center of the car seat.
Pull on the shoulder belt to tighten while feeding
the slack back in the retractor.
DO NOT pull on the belt with excessive force. If the
belt is too tight, you will not be able to close the
SnugLock® Lock-Off.
12. Close the SnugLock® Lock-Off
When the slack is removed, close the SnugLock®
Lock-Off until you hear a “CLICK!”. Make sure
the vehicle seat belt is under the SnugLock®
Lock-Off.
Note: When using the lock-off, you do not
need to switch the retractor to lock the vehicle
seat belt. The lock-off locks the seat belt.
It is recommended to switch the retractor after
the installation is complete to avoid a possible
strangulation risk.