3- Slide the unit into position in the fireplace making sure the insulation is depressed against
the masonry and sealing all edges of the Stove.
4- This step is important not only to prevent loss of warm room air but also to restrict Back
Draft.
ALTERNATIVE INSTALLATIONS
1- There are variations to most of the referenced installations mentioned in this manual.
2- Should you have any questions your installer or dealer will most likely know the best
approach for your situation.
3- Also feel free to call Grain Stoves Inc. if you are unsure about the procedures listed.
COMPONENT REFERENCE
CONTROL PANEL: Located on top right hand side of the Grain Comfort
FEED CONTROL: This Control is like the Thermostat in your home. The Higher the
Setting, the more Grain is fed into the Firepot and the more heat is generated. Over a period of
time, you will learn the best and most efficient settings for your particular installation.
POWER SWITCH: This red switch controls the power to the unit. As long as the Unit is ON,
the Combustion Fan will run. The Switch is illuminated to show its condition.
HI / LOW FAN CONTROL: Controls the amount of warm air entering the room. This
control regulates the airflow into the room. This does not affect combustion efficiency. Time has
shown that most users leave this control on high.
FUSE HOLDER: Contains a standard 5 amp fuse.
13
To Next Page
Loading...