PROBLEM CAUSE REMEDY
Auger Not Feeding
Not up to Temperature
120 Check fire Condition, add wood pellets if needed
Auger Switch not ON Turn ON FEED SWITCH
Auger Jammed Check for obstruction - jumper test
Auger Jammed Check Bearing for Jam - jumper test
Loose Wire Inspect wiring
120 Degree defective Replace if necessary
Timer Defective Test and replace if necessary
Overheated 200 Degree Tripped / Clean Stove
Auger and Circulating Fan OFF
Not up to Temperature
120 Check fire Condition, add wood pellets if needed
Fuse Blown Check Fuse
ON /OFF Switch Check Switch
Auger Runs Continuously Wire off Timer Check Wiring
Wire off Potentiometer Check Wiring
Timer Defective Check / Replace if necessary
Potentiometer Defective Check / Replace if necessary
Auger Stops Suddenly Fuse Blown Check Fuse
ON /OFF Switch Check Switch
Timer Defective Check / Replace if necessary
Overheated 200 Degree Tripped / Clean Stove
Flame Catching Chute on fire Auger Position Move Auger back by adjusting bearing mounting
Too much Corn Feeding Adjust Timer (consult Grain Stoves or Dealer)
Dirty Fuel To many Fines - use clean fuel
Exhaust plugged Clean Stove - Follow Cleaning Procedure
Running too Hot Turn Down Feed Rate
Burning Smokey and Black Plugged in Exhaust Clean Stove - Follow Cleaning Procedure
Plugged in Intake Clean Stove - Follow Cleaning Procedure
Plugged Muffler Screen Clean Out Muffler
Smoking when door opened Plugged in Exhaust Clean Stove - Follow Cleaning Procedure
Plugged Muffler Screen Clean Out Muffler
Condensation in Hopper Plugged in Hopper Tube Check for air flow from tube
Plugged in Exhaust Clean Stove - Follow Cleaning Procedure
Hopper Lid Tie-down Check presence of Lid and Tie down
Plugged Muffler Screen Clean Out Muffler
Clinker is hard to get out Running too Hot Turn Down Feed Rate
Too much Corn Feeding Adjust Timer (consult Grain Stoves or Dealer)
25
To Next Page
Loading...