In order to avoid bodily injury, reduced operational safety or damage to the seat resulting from improperly performed work, all
information and instructions, in particular the safety instructions stated in Chapter 1.1, must be read carefully and strictly
observed.
As an inevitable matter of fact, GRAMMER AG cannot evaluate all situations and consequences that may bear a risk of injury
for the persons involved in the described work procedures. For this reason it is absolutely necessary that every person who
carries out repair work at a seat uses his/her professional knowledge to make sure that his/her own safety will not be put at
and that the selected type of repair will not cause any negative effects, in particular with regard to technical safety.
For this reason, GRAMMER AG disclaims liability for any possible damage of this kind.
We point out explicitly that all work steps and procedures described are to be performed with consideration to the applicable
directives and regulations stipulated by the relevant local authorities and in compliance with the provisions on health
protection, prevention of accidents and environmental protection.
Change notification and copyright
The seats are subject to continuous development. Please understand that we must reserve the right to make changes in
shape, equipment and technical design. For this reason, the contents of this repair manual cannot be used to substantiate any
possible claims.
Reprint, translation and copies of this manual or parts thereof are admissible only after written approval.
GRAMMER AG ⋅ Postfach 14 54 ⋅ D-92204 Amberg Delivery and factory address:
Phone +49 (0) 96 21 / 66-6822 GRAMMER AG
www.grammer.com Köferinger Str. 9-13 ⋅ D-92245 Kümmersbruck
To Next Page
Loading...
