1 All inspection, test and repair work must be performed exclusively by adequately trained personnel.
2 All work steps and procedures described are to be performed with consideration to the applicable directives and regulations
stipulated by the relevant local authorities and in compliance with the provisions on health protection, prevention of
accidents and environmental protection.
3 Special notes in this repair manual are highlighted as follows:
WARNING … indicates possible risks for persons and their prevention.
ATTENTION ... indicates possible damage or destruction of material and their prevention.
Note: ... introduces an additional explanation for better understanding the work to be carried out.
Installation note: ... introduces an additional explanation for better understanding the installation work to be carried out.
4 Prior to all repair work, the following work has to be carried out:
• Disconnect the seat from the power supply.
• Bleed air out of the compressed-air system.
• Move the seat down to the end stops.
To Next Page
Loading...
