131
Slideout Systems
Ensure that the RV is
level before operating
the slideout room.
Water leaks and other
problems could result if
the slideout is operated
without leveling the RV.
The Slide Room Switches
are located inside the RV,
on the Command Center.
5. Inspect the sides, top and bottom of the extended slide-
out room. If the outside of the slideout room is wet, wipe
it dry before retracting.
6. Clean any water puddles or debris brought inside your
RV from slideout operation immediately.
7. Press and hold the appropriate slide room switch to
either IN or OUT, until the room is completely extended
or retracted.
• DO NOT hold the slide room switch past the point the
room is fully extended/retracted or damage may occur.
• For the weather seals to be eective, the slideout room
MUST be completely extended/retracted.
• BEFORE operating your slide systems, review all
important safety alerts.
Slideout maintenance
While the slideout room is extended, the outside surfaces of
the room and mechanism may collect dirt and debris. The
slideout seals are not designed to remove the debris or any
water that may accumulate.
• When you retract the slideout, any debris on the
outside of the room, is brought inside your RV.
BEFORE retracting the slideout(s):
• Inspect the outside surfaces for snow, ice, dirt, dust,
insect nests, etc.
• Check for standing water on the slideout topper awning
(if so equipped).
• Clean and dry the outside surfaces of the room and
mechanism as much as possible.
Contact your dealer or Grand Design RV Customer Service
for troubleshooting and/or repair if your slideout system:
• Stalls out before reaching end of stroke, or
• Does NOT close and seal tightly.
For long-term storage, it
is recommended that the
slide rooms be closed
(retracted).
Never ‘jump’ or charge the
auxiliary battery from the
power connections on the
InWall Controller. Always do
this at the auxiliary battery.
Inspect both sides of the
slideout room for interior or
exterior obstructions prior
to operating.
To Next Page
Loading...