Grandstream Networks GRP2601 - Experiencing GRP260 x; Product Updates and Support

P a g e | 57
GRP260x Administration Guide
Version 1.0.1.18
Network Settings Page Definitions
Table 11: Network Page Definitions
Network Settings → Ethernet Settings
Internet Protocol
Selects “IPv4 Only”, “IPv6 Only”, “Both, prefer IPv4” or “Both, prefer IPv6”.
The default setting is “IPv4 only”.
IPv4 Address
IPv4 Address
Allows users to configure the appropriate network settings on the phone to
obtain IPv4 address. Users could select “DHCP”, “Static IP” or “PPPoE”. By
default, it is set to “DHCP”.
IPv4 Address
Enter the IP address when static IP is used.
Subnet Mask
Enter the Subnet Mask when static IP is used for IPv4.
Gateway
Enter the Default Gateway when static IP is used for IPv4.
DNS Server 1
Enter the DNS Server 1 when static IP is used for IPv4.
DNS Server 2
Enter the DNS Server 2 when static IP is used for IPv4.
Preferred DNS Server
Enters the Preferred DNS Server for Ipv4.
IPv6 Address
IPv6 Address Type
Allows users to configure the appropriate network settings on the phone to
obtain IPv6 address. Users could select “Auto-configured” or “Statically
configured” for the IPv6 address type.
Static IPv6 Address
Enter the static IPv6 address when Full Static is used in “Statically configured”
IPv6 address type.
IPv6 Prefix Length
Enter the IPv6 prefix length when Full Static is used in “Statically configured”
IPv6 address type.
DNS Server 1
Enter the DNS Server 1 for IPv6.
DNS Server 2
Enter the DNS Server 2 for IPv6.
Preferred DNS server
Enter the Preferred DNS Server for IPv6.
802.1X
802.1X mode
Allows the user to enable/disable 802.1X mode on the phone. The default
value is disabled. To enable 802.1X mode, this field should be set to EAP-
• “Label” could be the description you want to use.
For details, please check the “Multicast Paging User Guide” on our Website.