Figure 4-8. IVR
14.Click on “Save” and Apply changes by clicking on the pink ribbon that appears at the
top of the page. Now go to “PBX => PBX Configuration => Inbound Routes”. Click on
“Add Incoming Route”. (Figure 4.9). Set the following:
Description: Name of inbound route (“Incoming_Calls” in this example)
DID Number: 999999
Set destination: Where the call will be routed. (“WelcomeIVR” IVR in this
example)
Figure 4-9. Incoming Route
15.Click on “Submit” button and apply changes. Now when we receive calls from PSTN to
the number 999999, the IVR will be played to the caller giving him choices to interact
with our Elastix Server.
16.To configure the GXW410x you will need to enter the information from the sip trunk
created on the Elastix Server into the gateway.
To Next Page
Loading...
