3
Euroflame Oil Boilers
The boiler will provide domestic hot water and central
heating and is fully automatic once switched on. An
illuminated On/Off switch, see Fig. A, is fitted to the
Euroflame Kitchen/Utility model, which lights when the
boiler is switched on, but does not necessarily indicate the
burner is firing.
To access the Kitchen/Utility model controls, pull the
front panel off (push-on fixings).
1 Ensure that - There is sufficient fuel, of the correct
type, in the supply tank and all fuel supply valves are
open. The water supply is on. The electricity supply
to the boiler is off. The boiler On/Off switch is set to
OFF (Kitchen/Utility models, the neon in the switch is
not alight). The room thermostat (if fitted) is at the
desired setting. The boiler thermostat is set to the
required setting (see section 1.7).
2 Switch on the electricity supply to the boiler.
Note: Boiler House models will light at this stage.
3 For Kitchen/Utility models, set the On/Off switch to
ON. A neon in the switch lights when it is in the on
position.
The boiler will now light automatically.
1 - USER INSTRUCTIONS
About your boiler
1.1
Boiler controls (see Fig. A or B)
1.2
Lighting your boiler (see Fig. A or B)
1.3
Controls for Euroflame Kitchen/Utility models - Fig. A
°C
90
75
60
Boiler
thermostat
Overheat thermostat
reset button
(under plastic cap)
Controls for Boiler House models - Fig. B
To Next Page
Loading...
