GRAPHTEC F-Mark - Page 18

- 15 -
* After attaching the Arm assembly to the main body of F-Mark2,
make sure that the Arm assembly is attached parallel to the main body of F-Mark2.
* Insert the air tube firmly into the air tube distributor when inserting the air
tube into the air tube distributor.
Arm assembly
6. Reattach the Arm assembly in the reverse order in which it was detached.
Make sure that the tip of the Insertion Flap is parallel to the tip of the
F-Mark2 main body.
If the Arm assembly is not attached paralle lto the main body of F-Mark2,
adjust the Arm position while referring to the “8. How to adjust the Arm position”.