JUPITER CM-4400 Control Module Installation and Operating Manual 155
Serial Protocol Table
Figure 110. Example of the MPK Entry in the Serial Protocol Table
Connecting L-S or LCD Series Control Panels
When L-S or LCD Panels are connected to a CM-4000 serial port (and oper-
ated in Serial mode), the CM-4000 serial port must be configured for
“ESCP” pr
otocol using the Serial Protocol table. The Baud rate should be
set at 115K. Use the CPES-SER type for panels to use up to 98 categories.
To Next Page
Loading...