JUPITER CM-4400 Control Module - Installation and Operating Manual 235
Telnet
The Telnet button opens telnet windows for the selected boards. For this
command to work, you must have a “telnet.exe” application somewhere in
your search path. The default TCP/IP Window’s installation will do this for
you. Note that if you have selected several boards, the telnet windows may
appear on top of each other. Simply move them to see the ones underneath.
Update Board Info
The Update Board Info button requests updated board information from the
boards. The control center does not poll for board information. It does
attempt to update board information when boards become active, but the
display may occasionally show incorrect information. If you suspect incor-
rect information is being shown, click the
Update Board Info button.
Configuration
The Configuration tab allows you to see a list of compiled sets and select a
set for activation. It also allows you to restore a previously activated set and
reboot the boards.
Figure 191. The Configuration Tab of the Control Center Application
Activating a Set
On the left side of the window, you will see a box that shows a list of com-
piled sets a set must be activated.
Follow these steps to activate a set:
1. Click the Configuration tab.
2. Click the name of the set that you wish to activate name in the list on
the left side of the dialog. The “ARDH_69e” set is selected in the
example shown in Figure192
3. Click the Select and Reboot radio button if it is not already selected.
To Next Page
Loading...