If upgrading both K2 and SNFS software, SiteConfig uninstalls both in the
proper sequence.
6. When the Status or Details columns indicate next steps, identify the software in
the row, then do one of the following:
• For SNFS software, when Details displays a Restart required link, click the link
and when prompted "...are you sure...", click Yes. After this restart, continue
with other restarts as indicated.
• For K2 software, if the version from which you are upgrading is lower than
7.1.0.1153, do not restart. Do not click the Restart required link displayed in
Details. Instead, you must power cycle the K2 system, as instructed in the next
task.
• For K2 software, if the version from which you are upgrading is 7.1.0.1153 or
higher, when Details displays a Restart required link, click the link and when
prompted "...are you sure...", click Yes.
7. Monitor progress as indicated by both the Status and Details column. When finished,
the Status column indicates complete.
Related Links
Upgrade software on stand-alone K2 systems on page 53
Power cycle K2 system on page 55
Power cycle K2 system
Do not do this task if:
• The standard, SiteConfig-supported Restart operation is sufficient for the required
restart after installing software.
Do this task if:
• You must power cycle, rather than restart, the K2 system after installing software.
When you must shutdown and then power up (power cycle) a device, rather than restart
the device, you must use a combination of SiteConfig and manual operations.
1. In the SiteConfig tree-view, right-click the device and select Shutdown.
SiteConfig initiates the Windows shutdown operation on the device and the
device powers off.
2. At the local device, verify that shutdown operations are complete, then press the
standby button or otherwise manually power up the device.
The device starts up.
3. Verify that startup operations are complete on the device.
4. In SiteConfig, in the tree-view, right-click the device and select Set Restart
Complete.
12 May 2010 K2 Version 7.2.7 Release Notes & Upgrade Instructions 43
Upgrading K2 systems
To Next Page
Loading...
