GRASS VALLEY K2 - Prepare Siteconfig for Software Deployment to Stand-Alone K2 Systems; Check All Currently Installed Software on Stand-Alone K2 Systems

2. On a stand-alone K2 system, verify, and if necessary modify, settings for required
values as follows:
# *********************************************************
# A global section for defining file system-wide parameters
# *********************************************************
GlobalSuperUser Yes
.
.
.
.
.
.
InodeDeleteMax 1000
3. Close, and if necessary save, the SNFS configuration file.
If you made changes, the K2 system must be restarted for the changes to take effect.
The restart later in this upgrade procedure is sufficient to put the changes into effect.
Prepare SiteConfig for software deployment to stand-alone K2 systems
Do the following to prepare SiteConfig for the software upgrade.
1. Make the following files accessible to the SiteConfig control point PC:
• K2 Summit Client Standalone software installation (*.cab) file.
2. If a newer version of SiteConfig is available for upgrade and you have not yet
upgraded SiteConfig, do the following:
a) From Windows Add/Remove programs, uninstall the current version of
SiteConfig from the control point PC.
b) Install the new version of SiteConfig on the control point PC.
3. If not already present in the SiteConfig system description, configure deployment
groups as follows:
• A deployment group that contains your stand-alone K2 systems
• A deployment group that contains your control point PC
Check all currently installed software on stand-alone K2 systems
Prerequisites for this task are as follows:
• The device is assigned in the SiteConfig system description and network
connectivity is present.
• SiteConfig is able to log in to the device using the username/password credentials
assigned to the device.
50 K2 Version 7.2.7 Release Notes & Upgrade Instructions 12 May 2010
Upgrading K2 systems