On a K2 Summit/Solo system, a message appears that informs you about the
write filter and prompts you to restart. Click OK and the K2 Summit/Solo system
restarts.
The service checks the source directory for files. If files are present, the service
moves them to the Archive sub-directory. It does not import the files into the
destination bin on the K2 system.
Upgrade K2 Dyno Server software
Do not do the tasks in this section if:
• The K2 Summit Production Client or K2 Solo Media Server is not controlled by
a K2 Dyno Controller and therefore K2 Dyno Server software is not installed.
Do the tasks in this section if:
• The K2 Summit Production Client or K2 Solo Media Server is controlled by a K2
Dyno Controller and you need to upgrade the K2 Dyno Server software. Refer to
compatibility specifications to determine if you need to upgrade.
Check the K2 Dyno Controller release notes for any updated information regarding
the upgrade process, then proceed with the tasks in this section.
Related Links
Compatible Grass Valley products on page 19
About K2 Dyno software
There are two software components in the K2 Dyno Replay system, as follows:
• K2 Dyno Server software – This software runs on the K2 Summit/Solo that is
controlled by the K2 Dyno Controller.
• K2 Dyno Client software – This software runs on the K2 Dyno Controller.
When installing/upgrading K2 Dyno software you must consider versions and
compatibility for both components: one on the K2 Summit/Solo and one on the K2
Dyno Controller.
Uninstall K2 Dyno Server software
If you have not already done so, disable the write filter on the K2 Summit Production
Client or K2 Solo Media Server.
On the K2 Summit Production Client or K2 Solo Media Server, use the Windows
Add/Remove Programs control panel and uninstall K2 Dyno Server software.
The display name of the software is K2 Dyno.
Do not restart the K2 Summit Production Client or K2 Solo Media Server.
64 K2 Version 7.2.7 Release Notes & Upgrade Instructions 12 May 2010
Upgrading K2 systems
To Next Page
Loading...
