7. In the Acronis main window, click Recovery.
The Restore Data Wizard opens.
8. On the Welcome page, click Next.
9. On the Backup Archive Selection page, in the tree view expand the node for the E: partition and
select the image file, then click Next.
10. On the Restoration Type Selection page, select Restore disks or partitions and then click Next.
11. On the Partition or Disk to Restore page, select (C:) and then click Next.
12. On the Restored Partition Location page, select (C:) and then click Next.
13. On the Restored Partition Type page, leave the selection at Active and then click Next.
14. On the Restored Partition Size page, leave settings at their defaults. The size reported in the
upper pane is the size detected of the actual C: partition. This should be the same as that reported
in the Partition size field in the middle of the page. Free space before and Free space after should
both be reported at 0 bytes. Click Next.
15. On the Next Selection page, select Yes, I want to restore another partition or hard disk drive and
then click Next.
16. On the Partition or Disk to Restore page, select (D:) and then click Next.
17. On the Restored Partition Location page, select (D:) and then click Next.
opens.
18. On the Restored Partition Type page, leave the selection at Primary and then click Next.
19. On the Restored Partition Size page, leave settings at their defaults. The size reported in the
upper pane is the size detected of the actual D: partition. This should be the same as that reported
in the Partition size field in the middle of the page. Free space before and Free space after should
both be reported at 0 bytes. Click Next.
20. On the Next Selection page, select No, I do not and then click Next.
21. On the Restoration Options page, do not make any selections. Click Next.
22. On the “…ready to proceed…” page, verify that you are restoring the correct image to the correct
location. Click Proceed.
23. On the Operation Progress page, observe the progress report.
24. When a “The data was successfully restored” message appears, click OK.
25. Click Operations | Exit to exit the Acronis True Image program.
The machine restarts automatically.
26. Remove the recovery media while the machine is shutting down.
Next, do the following to restore the K2 Media Server to its factory-default state. Refer to related
topics in this document or as otherwise indicated.
1. Set up Windows.
2. Restore network configuration.
3. Install K2 software and SNFS software. Refer to related topics in "K2 Release Notes".
4. Install the SiteConfig Discovery Agent.
5. Install Fibre Channel Card driver.
6. Activate Windows within 30 days.
Related Topics
Installing the Fibre Channel card driver on page 296
02 February 2012 K2 SAN Installation and Service Manual 121
Managing K2 Software
To Next Page
Loading...
