Control point PC
• Ethernet cable connected
• Control Point software installed
• Control network IP address assigned
• Network communication over the control network with all other K2 devices
• Power on
Ethernet switch
• Ethernet cables connected
• Control network IP address assigned
• VLANs set up
• Trunks set up
• Power on
K2 Media Server
• Ethernet cables connected
• Fibre Channel cable connected
• Software installed, as from the factory, including QuickTime 7
• Control network IP address assigned
• Power on for all servers
K2 RAID chassis
• Fibre Channel cable(s) connected
• Ethernet cable(s) connected
• Power on
K2 RAID Expansion chassis (optional)
• Fibre channel cable(s) connected
• Power on
128 K2 SAN Installation and Service Manual 02 February 2012
Configuring and licensing the K2 SAN
To Next Page
Loading...
