• Disks bound
1. If you have not already done so, launch Storage Utility from the K2Config application.
2. As prompted, wait while Storage Utility gathers system information, then Storage Utility opens.
3. In Storage Utility, click Tools | Make New File System.
The Setting dialog box opens.
4. For the Real Time Input/Output (RTIO) rate, enter the value specified by your system design.
If you do not know this value, contact your Grass Valley representative.
5. Configure Windows Security as follows:
• If the K2 SAN is to be accessed by only K2 clients leave Windows Security unchecked.
• If the K2 SAN is to be accessed by Aurora Edits, refer to the Aurora Edit Installation and
Configuration Guide for instructions.
02 February 2012 K2 SAN Installation and Service Manual 141
Configuring and licensing the K2 SAN
To Next Page
Loading...
