Configure Define Server Roles page - Redundant K2 SAN server A and server B
1. Enter the name for the K2 Media Server, as currently configured on the machine.
2. Enter the name or IP address of the Ethernet switch, as currently configured on the switch, to
which the K2 Media Server is connected.
3. Select all roles, except as follows:
If the K2 SAN has one or more optional NH servers, then FTP traffic should go to the NH server,
not the K2 Media Server you are now configuring. In this case, do not select the FTP server role
or the NAS server role
4. Click Next.
The Software Configuration page opens.
02 February 2012 K2 SAN Installation and Service Manual 157
Configuring and licensing the K2 SAN
To Next Page
Loading...
