Configure File System Server Configuration page - Redundant K2 SAN server B
This page checks on the configuration of the K2 Media Server in one of its main roles as a file
system server. The K2 Media Server also functions as a file system client, which is also checked
from this page. It is not necessary to bind RANKs or create a file system, since this task was
completed when you configured the previous K2 Media Server.
1. If desired, configure reference file generation.
2. Click Check.
3. Confirm a “… file copied…” message.
4. When the wizard reports that the configuration is correct, click Next.
5. Confirm messages about copying the file system configuration file to the other server.
If you get a “The V: will not be available until this device is rebooted…” message, you can safely
continue now and reboot later when instructed to do so.
The iSCSI Bridge Server Configuration page opens.
Related Topics
Configuring reference file type on a K2 SAN system on page 280
02 February 2012 K2 SAN Installation and Service Manual 177
Configuring and licensing the K2 SAN
To Next Page
Loading...
