Configure Network Configuration page - NH server
This page displays the control network Ethernet port, and allows you to configure the FTP/Streaming
network Ethernet port.
1. Verify that the top port is configured correctly.
The top port is the port over which the K2Config application is communicating. If correctly
configured, it is already assigned the control network IP address, as displayed on this page.
2. Verify that the FTP/Streaming port is configured correctly. If not configured correctly, do the
following:
a) Select the other port and click Modify.
A network configuration dialog box opens.
b) Enter the FTP/Streaming IP address and the subnet mask and click Apply.
3. Click Next.
The File System Server Configuration page opens.
02 February 2012 K2 SAN Installation and Service Manual 195
Configuring and licensing the K2 SAN
To Next Page
Loading...
