Configure File System Server Configuration page - NH server B
This page checks on the configuration of the K2 Media Server in one of its main roles as a file
system server. The K2 Media Server also functions as a file system client, which is also checked
from this page. It is not necessary to bind RANKs or create a file system, since this task was
completed when you configured the previous K2 Media Server.
1. Do not select Reserved Bandwidth unless instructed to do so by Grass Valley. This system is
usually not configured for RVIO.
2. Click Check.
3. Confirm a “… file copied…” message.
4. When the wizard reports that the configuration is correct, click Next.
5. Confirm messages about copying the file system configuration file to the other server.
If you get a “The V: will not be available until this device is rebooted…” message, you can safely
continue now and reboot later when instructed to do so.
The iSCSI Bridge Server Configuration page opens.
226 K2 SAN Installation and Service Manual 02 February 2012
Configuring and licensing the K2 SAN
To Next Page
Loading...
