GRASS VALLEY K2 - Page 66

23. Enter the SNMP community and IP address of the NetCentral server PC. The commands are
slightly different on HP 2900 and HP 2910 switch models.
For example, if the IP address is “192.168.40.11” and the community is “public”, you type one
of the following as per your switch model, then press Enter:
HP 2900: snmp-server host public 192.168.40.11
HP 2910: snmp-server host 192.168.40.11 public
24. Enable Authentication traps. To do this, type the following, then press Enter:
snmp-server enable traps snmp-authentication standard
This allows NetCentral to test the switch to verify that it can send its SNMP trap messages to
NetCentral.
25. Type the following, then press Enter:
menu
When prompted, save the configuration by pressing the y key.
The main menu opens.
26. If you need a trunk for ISLs to gang switches together, use the following steps. These steps
illustrate trunking the last three 1 Gig ports for three 1 Gig ISLs, which is the recommended
configuration for ISLs on all multi-switch K2 SANs. Consult with your Grass Valley representative
if your requirements deviate from the recommended policy:
a) At the main menu, select Switch Configuration and press Enter.
b) Choose selection Port/Trunk Settings and press Enter.
c) Press the right-arrow key to choose Edit, then press Enter.
d) Down arrow until at the bottom of the list of ports and select the last (highest port number)
1 Gig port in the list.
e) Right-arrow over to the Group column.
f) Use the Space bar and set the bottom 1 Gig port to Trk1.
g) Set the next port up also to Trk1.
h) Set the next port up also to Trk1.
i) Press Enter, then right-arrow to Save. Press Enter and revert to previous menu.
27. Select Return to Main Menu and press Enter.
28. From the main menu, tab to Command Line (CLI) and press Enter. The command prompt appears.
29. Check the version of firmware on the switch. To do this, type the following, then press Enter:
show flash
Information is displayed similar to the following example:
HP_iSCSI_switch1# show flash
Image Size(Bytes) Date Version
----- ---------- -------- -------
Primary Image : 6737518 07/25/08 T.13.23
Secondary Image : 5886358 10/26/06 T.11.12
Boot Rom Version: K.12.12
Current Boot : Primary
30. Check the Primary Image Version and refer to related topics in "K2 Release Notes" for information
about currently supported versions. If instructed to change the firmware on the switch, do so
before continuing.
66 K2 SAN Installation and Service Manual 02 February 2012
Setting up the K2 SAN infrastructure