46 K2 Storage Cabling Guide 03 September 2009
Chapter 2 Cable K2 devices
Cable NH1 K2 Media Server
As directed by the system diagram for your K2 SAN’s level, cable the NH-1 K2
Media Server or Servers for your K2 SAN using the instructions in this section.
• “Dell 1950 NH1 for online K2 SAN” on page 46
• “Dell 1950 NH1 for basic nearline K2 SAN” on page 46
• “Dell 1950 NH1 for redundant nearline K2 SAN” on page 47
• “Dell R610 NH1 for online K2 SAN” on page 47
• “Dell R610 NH1 for redundant nearline K2 SAN” on page 48
Dell 1950 NH1 for online K2 SAN
These cabling instructions apply to the following:
• Dell 1950 PowerEdge Server NH1 on an online K2 SAN.
Dell 1950 NH1 for basic nearline K2 SAN
These cabling instructions apply to the following:
• Dell 1950 PowerEdge Server NH1 on a basic (non-redundant) nearline K2 SAN.
12
Gb 2Gb 1
Fibre Channel
to RAID controller
To control port
on GigE switch
FTP: To control port
on GigE switch
12
Gb 2Gb 1
Fibre Channel
to RAID controller
To control port
on GigE switch
FTP: To control port
on GigE switch
To Next Page
Loading...
