03 September 2009 K2 Storage Cabling Guide 49
Cable NH1-10GE K2 Media Server
Cable NH1-10GE K2 Media Server
As directed by the system diagram for your K2 SAN’s level, cable the NH1-10GE K2
Media Server or Servers for your K2 SAN using the instructions in this section.
• “Dell 1950 NH1-10GE for online K2 SAN” on page 49
• “Dell 1950 NH1-10GE for basic nearline K2 SAN” on page 49
• “Dell 1950 NH1-10GE for redundant nearline K2 SAN” on page 50
• “Dell R610 NH1-10GE for online K2 SAN” on page 50
• “Dell R610 NH1-10GE for basic nearline K2 SAN” on page 50
• “Dell R610 NH1-10GE for redundant nearline K2 SAN” on page 51
Dell 1950 NH1-10GE for online K2 SAN
These cabling instructions apply to the following:
• Dell 1950 PowerEdge Server NH1-10GE on an online K2 SAN.
Dell 1950 NH1-10GE for basic nearline K2 SAN
These cabling instructions apply to the following:
• Dell 1950 PowerEdge Server NH1-10GE on a basic (non-redundant) nearline K2
SAN.
12
Gb 2Gb 1
FTP: To 10 Gig port
on GigE switch
Fibre Channel
to RAID controller
To control port
on GigE switch
12
Gb 2Gb 1
To control port
on GigE switch
FTP: To 10 Gig port
on GigE switch
Fibre Channel
to RAID controller
To Next Page
Loading...
