98
Specifications
Kahuna 9600, Kahuna 6400 Mainframe Specifications
Mainframe Input Fin Formats & Levels
(Optional) UHDI
12Gbps
Input Fin
3x UHD BNCs SMPTE ST 2082-10
3x SFP + complaint cages
11.88Gbps Video Standards (UHD)
GPO (Tally)
outputs
Mainframe
1 x 25 Way D-type GPO Tally on each Input Fin with isolated contact closures.
(10 x 25 Way D-type GPO Tally connectors if all Input Fins are fitted)
SDI Input Format Tri Standard 1080p 2.97Gbps/HD 1.485 Gbits/second and SD 270Mbits/second
serial digital interface as per ANSI/SMPTE-259/292M
Analogue HD
Reference
±300mV tri-level sync 6dB
Analogue SD
Reference
300mV sync with optional 300mV pk-pk burst 6dB
Impedance: 75 ohms (except reference input).
FDI Fiber Fin
Module
Requirements
Input Fiber Optic SFP Module - Single Mode Dual Rx Module
(wideband 1260nM - 1620nM)
Receiver(s) = PIN + TIA
Wavelength = 1260nM - 1620nM
Sensitivity = -25dBm typical, -21dBm max
Input Coax SFP Module - Dual Rx Coax, Mini BNC Module
40GbE IPI40 (IP
Input)
Signals supported over RTP stream per input Fin Module. 2 x 40GbE QSFP Cages.
SFP + Optical 2 x 40G Ethernet
Conforms to IEEE 802.3ba – 40Gigabit over fiber.
SFP + connected Cable 2 x 40Gigabit Ethernet over twin axial cables.
50GbE IPI50 (IP
Input)
Signals supported over RTP stream per input Fin Module. 2 x 50GbE QSFP Cages.
SFP + Optical 2 x 50G Ethernet
Conforms to IEEE 802.3ba – 50Gigabit over fiber.
SFP + connected Cable 2 x 50Gigabit Ethernet over twin axial cables.
UHDI 12Gbps
Input Fin
11.88Gbps Video Standards (UHD)
3840 x 2160p 50Hz, 3840 x 2160p 59.94Hz, 3840 x 2160p 60Hz, 11.88Gbps Video
Signals (UHD) >= 70m of Belden 1694A cable
To Next Page
Loading...
