GRASS VALLEY KAHUNA 9600 - How to calculate a Desk Cut-out Width and Depth

17
Kahuna
Installation Manual
How to calculate a Desk Cut-out Width and Depth
Cut-out Width - The calculation is:- 
Total Width MAV Modules and Blanking Modules in a row + 29 mm (1.14 in).
Cut-out Depth - The calculation is:- 
Number of Rows x 140 mm - 5 mm (Number of Rows x 5.15 in - 0.19).
Example: 
In the diagram below, the black line is the outline of if control surface from the previous page.
The calculation below describes how to calculate the cut-out (red dotted line) for the control
surface.


Cut-out Width - Add up all the Widths of the MAV modules (bottom row):-
160 mm + 160 mm + 200 mm + 160 mm + 100 mm = 780 mm
Then add 29 mm to that total:- 780 mm + 29 = 809 mm (cut-out Width).
Calculation in Inches:- 
6.29 in + 6.29 in + 7.87 in + 6.29 in + 3.93 in = 30.67 in 
Then add 0.98 into that total:- 30.67 in + 1.14 = 31.81 in (cut-out Width). 

Cut-out Depth - 140 mm x 3 = 420 mm, then take away 5mm = 415 mm (cut-out Depth).
Calculation in Inches:-
5.15 in x 3 = 15.45 in, then take away 0.19 in = 15.26 in (cut-out Depth).
Note: The cutout has to be a minimum of 110mm (4.3 inches) into the desk
to allow clearance for cables and airflow underneath the MAVRow frame.
Note: Widths of MAV Modules and Blanking Modules can be found in Table
1 and Table 3 of this manual.
809 mm
415 mm
CUT-OUT Area Red Dotted Line
Example of a Control Surface Cut-out