47
Kahuna
Installation Manual
Mainframe Connections
The Kahuna 9600 Mainframes have Ethernet, Serial, Tally & GPI I/O ports.
The Ethernet ports are used for connection between the mainframe and the GUI, to connect to
a network.
Output Fins
There are 16x SDO outputs on each Output Fin (64 Outputs in total (11RU Mainframe), 32
Outputs in total (6RU Mainframe) with all Output Fins installed), the diagram below shows the
4 output fins as would be seen looking at the rear of the 11RU mainframe.
Note: The following pages that describe the mainframe Fins are for the
11RU Mainframe (unless indicated otherwise). The 6RU mainframe Fins are
identical, taking into account that there is no second REF Fin, NET Fin or
second pair of Output Fins.
Fin O/P A
Fin O/P B
1
16
1
16
Fin O/P C
Fin O/P D
1
16
1
16
Left Side
Right Side
To Next Page
Loading...
