63
Positioning the MAV and Blank Modules
MAV Modules
Kahuna Maverik is a completely modular control surface, this means that the user is able to
change the layout of the control surface to suit any user preference or production
environment. The MAV modules can be easily lifted out of the MAVRow frame and be placed in
any configuration the user wishes.
With the MAVRows and Comms cables now fitted into the MAVRow frame, the next step is to fit
the MAV modules into the MAVRow.
Fitting the MAV modules into the MAVRow is a simple process, there are four locating pegs on
the underside of each MAV, the pegs slot into keyway holes on horizontal rails in the MAVRow.
Note: Care should be taken when handling MAV modules not to damage
the surface edges. Do Not apply any force to the control knobs on the GUI-
MAV or buttons on MAV modules.
Note: Connecting the Comms cables, Network cables and the external
PSU’s to the MAVs/MAV-GUI is covered in the previous section of this manual.
Locating Pegs
Locating Pegs
Locating Pegs
Under Side of
MAV
MAVRow viewed from above
Keyway Holes
To Next Page
Loading...
