64
Positioning the MAV and Blank Modules
MAV Modules
Connect the comms cables to the MAV modules, then carefully place the MAV Locating Pegs
(on the underside of the MAV) into the keyway holes and slide the MAV to the right until it is in
the locked position. Each MAV module will butt up tight against the next MAV or Blanking
module to its immediate right (as shown in the diagram below).
Note: On the right hand side of every MAV module and Blanking module is
a black foam protection strip. When fitting the modules, one foam strip
should not touch another foam strip. This can be a mistake made when
fitting Blanking modules.
Locating Pegs into
Keyway Holes an
slideto the right
Foam Protection
Strip
To Next Page
Loading...
