65
Kahuna
Installation Manual
Blanking Modules
Blanking Modules are designed to fill in the empty spaces in a MAVRow where MAV modules
are not required, they fit into the MAVRow frame in exactly the same way as fitting a MAV
module (as mentioned on the previous page).
The blanking modules have locating pegs which fit into the keyway holes and slide into a
locked position.
The widths of the blanking modules are in 20 mm (0.78 inch) increments, the smallest is 20mm
(0.78 inch) up to 220 mm (8.66 inches).
Note: On the right hand side of every MAV module and Blanking module is
a black foam protection strip. When fitting the modules, one foam strip
should not touch another foam strip. This can be a mistake made when
fitting Blanking modules.
Example of a Blanking Module
Example of a 2M/E Kahuna Maverik Control Surface
Blanking Modules highlighted by red dotted line
Foam Protection
Strip
To Next Page
Loading...
