KARRERA K-FRAME — User Manual 105
About DPMs
Enable DPM Transforms in the Menu
The Transform menu contains a data pad matrix in the upper left for dele-
gation (Figure 57). Data pads for keyers with DPMs assigned will be active.
Inactive keyers will be grayed out. Touch an active data pad to delegate the
menu to control keyers, or to control a Global
Channel (see DPM Global
Channel Assignments). The keyer data pads themselves indicate whether
Crop is enabled, Global Assignment is on, and if the Key Signal is off.
DPM Global Channel Assignments
The Primary Global and Secondary Global Channels are assigned in the
iDPM, Transform menu, however the Secondary Global channel requires
configuration in the ME, Mode menu (see
Set Up a DPM Secondary Global
Channel on page 140).
When a keyer is assigned to a Global Channel, it is also affected by trans-
forms of that Global Channel, permitting the easy creation of complicated
multi-channel moves. Multiple keyers can be assigned to a Global channel,
allowing coordinated moves of all the assigned keyers.
A keyer is associated with the Global channel by delegating the keyer, then
touching the
Global modifier button in the ME/Keyer matrix on the upper
left side of the Transform menu so it is illuminated (
Figure 58). Using the
Multi select button, more than one keyer can be selected at a time. The first
keyer matrix button selected with the Global channel turns blue while sub
-
sequent buttons are outlined in blue when touched.
Some functions (Crop, Reverse, Skew, Aspect, and Post Transform) are
inactive for these Global Channels so they are grayed out. Global Channel
assignment information will appear in the ME/Keyer data pad (
PRI Glb /
SEC Glb).
To Next Page
Loading...
