164 KARRERA K-FRAME — User Manual
Section 5 — Switcher Control
Macro Button Function Summary
The Macro button on the Control Panel, (one per Source Select area) dele-
gates keyer source select button Rows 1 and 2 for macro operations and
reports that macro mode is active (MCR appears in the bus display). To del
-
egate one bus row for macro operations, press and hold down the Macro
button, then press a bus delegation button for the row to be delegated.
MCRO appears in the bus display reporting that the row is active for macro
operations. Macro names, when displayed, will also appear on the bus
row(s).
For information about the Pre-Attached (Pre button), Post-Attached (Post
button), and Replacing (
Replace button) attached macros, see Macro Attach-
ments on page 162.
The Att Enable button enables and disables all macro button attachments
globally. When on, pressing Control Panel buttons with macros attached
will run those macros. When off, macros can only be played back by acti
-
vating macro mode and pressing the macro register buttons, or with the
Macro menu.
The Show (Attach) button activates a mode that low tally blinks Control Panel
buttons that have macros attached.
The Delete button activates macro Delete mode. When delete mode is on,
pressing a macro button deletes the macro associated with that button.
When macro mode is on, pressing the Replace button activates attach mode.
You then select the macro register of the desired pre-defined macro and
press the button to which you wish to attach that macro.
During a macro recording, time delays can be inserted into macros. The Ins
Delay
button activates macro Insert Delay mode. In this mode the macro del-
egated ME’s source name displays show time durations which can be
selected by pressing the corresponding keyer buttons.
The Record button activates or terminates macro Record mode. In this mode,
you select the macro register into which you wish to record, using the del
-
egated keyer row, perform the desired actions, and then finish the
recording by either pressing the
Record button again or pressing the newly
recorded macro register button.
Macro Menus
The Macro menus provide access to many, but not all, GV Switcher system
macro functions. The Macro menus are useful to access and use Macro reg
-
isters not available on the Control Panel (registers 25 or 33 through 50).
To Next Page
Loading...
