KARRERA K-FRAME — User Manual 169
Performing Macro Operations from the Menu
2. Select the Panel Name data pad next to the desired macro register.
3. Enter a four-character name in the pop-up keyboard, and touch Enter.
Note If there is no Panel Name entered, the Macro menu in the Local E-MEM
Module will display the macro register number; it does not dis play the OLED
name.
Attaching a Macro
1. Go to the Macros Attach menu (touch Macros, Attach) (Figure 94.
Figure 94. Macros Attach Menu
2. Select the button you wish to attach a macro to. You can either touch the
physical panel button while
Show Attach mode is active, which will scroll
to and blink that button on the Macros Attach menu, or you can use the
menu to select the panel section and then scroll the Macro Attachments
list to display the desired button.
3. Touch the Pre, Replace, or Post parameter touch button (upper right).
4. Touch the menu button for the macro register to be attached.
5. If desired, name the macro by touching the Name data pad and
entering the name in the pop-up keyboard. Press
Enter.
To Next Page
Loading...
