GRASS VALLEY KARRERA K-FRAME - Transitions Using E-MEM; Aux Bus Transitions

KARRERA K-FRAME — User Manual 241
Transitions Using E-MEM
Figure 132. Master Keyer Transition Area
To perform a keyer cut/auto cut transition, select an ME button
(ME1—ME4, PGM) and then press a key cut or auto cut button (the transi-
tion rate for Auto Key cut transition buttons is set in the delegated ME).
The ME buttons tally the color assigned to the ME (as with the Modifier
area); high tally for the selected ME, low tally if not selected. If the ME is
not available to the suite, no button color is present.
Transitions Using E-MEM
Transitions can also be built into E-MEMs. See E-MEM Transitions on
page 258.
Aux Bus Transitions
You can perform Aux bus transitions and mix or wipe between sources on
an Aux bus. GV Switcher allows you to use one or more ME partitions to
perform mixes or wipes on multiple aux busses (including
“Controller
MEs”).
To perform a mix, a wipe, or a mixture of both transition types for a show,
you will need to allocate ME resources in the User Setups, Suite Prefs,
Resource Allocation menu (
Figure 133).
8805_07
Key1
CutCut
Key2
CutCut
Key4
CutCut
Key3
Cut
Cut
Key6
CutCut
Key5
CutCut
MEME
3
MEME
2
PGMGM
MEME
4
MEME
1
Key 1
Auto
to
Key 2
Autoto
Key 3
Autoto
Key 4
Auto
to
Key 5
Autoto
Key 6
Autoto