KARRERA K-FRAME — User Manual 255
E-MEM Learn Auto Recall
E-MEM Learn Auto Recall
Each E-MEM register contains header information, along with keyframe
data. This header information applies to the entire effect and is not key
-
framable. Register header information includes:
• E-MEM enable group button selections (for Auto Recall)
• Effect Dissolve state (on or off)
• Effect Dissolve rate (seconds, frames, field)
When an effect is edited in the standard manner (Insert Before/After,
Modify Keyframe, Modify
All), only keyframe data is affected. The header
information does not change. In a standard Learn operation, all existing
keyframe data is overwritten with a single keyframe, and new header
information is saved.
Learn Auto Recall can be used to update E-MEM register header informa-
tion without changing keyframe data. To use this feature, select the state of
the desired header information, press
Lrn (top left soft button) then Auto
Recall
(top left hard button) on the Master E-MEM area. Examples are pre-
sented below:
Changing the Enable Groups Associated with Auto Recall
Press Auto Recall so it is on, select the desired Master E-MEM area Enable
buttons for the desired groups of levels, then press
Lrn, Auto Recall.
Setting the Effect Dissolve Rate
Press Lrn, Diss, Rate (in the Master E-MEM display), in the Master E-MEM
area, type seconds, frames, or fields, then press the button for the register
you wish to apply the effect dissolve rate.
Changing Path Control Values in an Effect
Path control determines how interpolation is performed through key-
frames. S-Linear, Linear, and Curve path types are supported, in addition
to Path Hold. These path types provide fine control of the dynamics of the
effect. See for background information.
1. Move to the location in the effect that you wish to change.
To Next Page
Loading...
