KARRERA K-FRAME — User Manual 303
ME Split Mode Operation
Transition Area
When the controls of a split ME are delegated to only one partition, the
ME's main transition system controls only that partition. Moving the Tran
-
sition Lever Arm or pressing the Auto Tran or Cut buttons will affect only the
delegated partition. Only elements assigned to that partition may be
selected for the next transition. Keyers associated with the other partition
may not be selected and therefore can not be included in the transition.
When a split ME has been delegated to both partitions, all the controls
become functional and simultaneous transitions in both partitions will
occur for what ever elements are selected.
As an exception to the independence of the two partitions, the six Key Cut/
Auto buttons (Figure 174) can always be used regardless of partitioning and
panel delegation. If a keyer is associated with the secondary partition, the
“Keyer-On” oval indicator is split in two and a secondary indicator is dis
-
played near the bottom in the Transition area’s OLED for the selected
element (
Figure 174).
Figure 174. Split ME Mode, Transition Area
Possible Out of Sync Transition Lever Arm
If a split ME is delegated to a different partition when a transition is in
progress, an out of sync condition of the transition lever arm will probably
result. This situation is similar to recalling an E-MEM register that splits the
screen with a transition wipe. The Transition Lever Arm will need to be
re-synced (by moving the lever arm to a limit) before it can be used to finish
the transition or start a new one.
Mix
Transns
PVW
Ps t
BLK
Key
1
Key
2
Key
3
Key
4
Key
5
Key
6
Key 1
Transns
Key 2
Transns
Key 3
Transns
Key 4
Transns
Key 5
Transns
Key 6
Transns
CutCut
AutoAuto
Key
Prior
Wipeipe
1
Wipeipe
2
Userer
1
Userer
2
8805_06
Cam8
M1A
Blk
Blk
Wip1
Cam8
1234
Blk
Blk
Cam8
M1A
Blk
Blk
1234
1234
Wip1
3>4
1234
1234
Wip1
3>4
1234
1234
Wip1
3>4
1234
1234
Wip1
3>4
To Next Page
Loading...
