KARRERA K-FRAME — User Manual 41
Patching a Key Input from One Source to a Different Source Using Patch Key
Patching a Key Input from One Source to a Different Source
Using Patch Key
You can patch a key from a different source using Patch Key.
1. Touch User Setup, Suite Prefs, Source Patch (Figure 17).
Figure 17. Source Patch Menu
2. Touch the data entry pad in the Patch Key column for the Logical ID
you wish to patch a key from a different source.
3. Touch the Eng or Fixed source in the Sources scrolling list containing
the key you wish to patch (LOGO KEY in the example in
Figure 16) or
press the Patch Key Source ID data pad and enter the Source ID number for
the key you wish to patch, and press
Enter.
Result: The key signal for Logical ID 19 (LOGO KEY) is now paired with
the Logical ID 16 (RED VID) video signal (
Figure 16).
Example: The example in Figure 16 shows three different video sources
over the same key signal, in this case the station logo. The three logos are
defined as RED LOGO, BLU LOGO, and GRN LOGO in the menus and as
RLGO, BLGO, and GLGO in the Panel Name which will be displayed on
the OLEDs of the keyer source select buttons when assigned to the Control
Panel.
To Next Page
Loading...
