130 KARRERA — Installation & Service Manual
Section 5 — Basic Configuration
2. Choose the Engineering Source in the scrolling list on the right. The
name of the source will be displayed on the Relay button.
•The None button clears the current Source assignment for the selected
relay.
•The Source Number data pad and scroll dial can be used to quickly select
the desired Engineering Source.
•The Lock button can be used to prevent the source list from scrolling
automatically to that relay’s source. This permits easy selection of adja
-
cent sources.
ClipStore Configuration
ClipStore basic configuration includes preparing the Summit/Solo and
Karrera systems through licensing, IP addressing, software installation,
cabling, and Karrera menu configurations.
Summit/Solo Software Version
The latest version of the ClipStore server software is available on the Grass
Valley Switcher Software Download site.
CAUTION Do not use AppCenter Elite software for ClipStore from the Summit/Solo
server web site as it may not be compatible.
For more information about installing and updating AppCenter Elite soft-
ware, see the Summit/Solo manuals.
Summit Preparation
Setting the IP Address
The ClipStore Summit/Solo server is shipped with the following defaults:
• IP Address: 192.168.0.180
• Mask: 255.255.255.0
• Gateway: 192.168.0.1
• WINS: disabled (0.0.0.0)
• DNS: disabled (0.0.0.0)
You can temporarily change the default settings using Netconfig (see the
NetConfig Network Configuration Application Instruction Manual at
www.grassvalley.com).
To set a new IP Address at the ClipStore (Summit/Solo) server, see Setting
the Summit/Solo IP Address on page 139.
To Next Page
Loading...
