KARRERA — User Manual 209
Transitions
To Perform a Lever Arm Transition
Setup:
1. Select the next transition button(s) for the element(s) involved (Bkgd,
Key
1-6, Key Prior.). Selecting one element button disables any others
selected. Holding down one button while pressing another selects both
elements, allowing all the transition elements to be activated if desired.
2. Select the type of transition (Mix, Wipe 1/Wipe 2, or User Transitions).
3. Select any new sources involved in the transition:
• If performing a background transition, select the new source to
transition to on the B bus.
• If you are transitioning in a new key, select that new source on the
key bus.
• If you are changing key priority, specify a new key priority in the
Keyer Priority menu.
4. If desired, select a transition modifier (Trans PVW or Preset Black).
Perform:
5. Move the transition lever arm. The picture will transition only the
elements selected. Other elements will remain unchanged.
To Perform an Auto Transition
Setup:
1. Setup for an Auto Transition is the same as a lever arm transition (see
page 209) with the following added step:
2. Specify the duration of the transition in the Local or Master E-MEM
area by pressing the
Menu button, then Trans Rate button, selecting the
flashing button of the desired element, and entering a value in
<seconds> • <frames> • <field> format (
Time Value Entry on page 127).
Different durations can be specified by repeating this process for each
element.
Perform:
3. Press the Auto Trans button. The picture will transition only the elements
selected at the specified rate(s). Other elements will remain unchanged.
To Next Page
Loading...
