330 Kayak — User Manual
Section 6 — System Operation
Matte Menu Controls
Use the following procedure to change matte settings in any of the Matte
menus.
• Go to the corresponding Mattes menu.
• If not already selected, touch the
Wash Control data pad to bring up the
Wash Source selection and the control for
Size/Offset and Softness via
digipot controls.
• If necessary, use the
Size/Offset and Softness knobs to make the wash edge
visible on the screen.
Size/Offset
Normally this parameter is named Size. When you are e.g. adjusting the
Border Matte for a wipe generator for a background transition, which uses
the same wipe generator for wash control as is used for the wipe transition
itself, it is named offset.
Figure 253. Matte Menu, Wash Control Selected
• Touch the Base Color data pad and use the top three digipots to adjust
Hue, Saturation, and Luminance of the base fill color (See Figure 254 on
page 331).
• Touch the
Wash Color data pad to delegate the digipots on the right to
adjust
Hue, Saturation, and Brightness of the wash fill color (See Figure 255
on page 331).
To Next Page
Loading...
