Kayak — User Manual 345
Pattern Mix
Pattern Mix
The Kayak system can combine the complex wipe pattern generators (Wipe1
and
Wipe2), to create a wide variety of customized wipes.
To Create a Pattern Mix
1. Double press the Wipe button in the Transition subpanel on the Main
panel. This selects
Wipe as the next transition type and also opens the
Wipes menu with Wipe1 delegated for control.
2. Select the Wipe1 pattern to be used by touching the Pattern data pad, and
then selecting one of the displayed patterns.
3. Touch the Mix, Ratio, etc. data pad.
4. Press the Trans PVW button in the Transition subpanel, and move the
lever arm part way. This will display the Wipe1 pattern on preview.
5. Set Wipe delegation to Wipe2 and select the desired pattern to be mixed
with Wipe1.
6. You can select the type of pattern mix with the Mix type buttons (Mix,
NAM +, NAM –
). The NAM buttons are used for And or Or pattern mixing.
7. You can also adjust the amount each wipe pattern contributes to the mix
with the
Ratio control digipot. At 50%, each pattern contributes equally.
At 25%, the other pattern contributes only 25% to the final pattern.
Note It is always Wipe1 which is adjusted for pattern mix, i.e. you are mixing
Wipe1 with Wipe2. Not Wipe2 with Wipe1.
To Next Page
Loading...
